When Using Stereo Tool DSP My Stream Skips & Buffers

If you find that your stream buffers or skips when using Stereo tool then you may need to adopt some of the settings below. To change these settings you will need to enable the advanced settings from the configuration menu.

1. Parallel Threads:
Ensure this is set to the number of cores you have in your processor (This is usually 4)

2. Latency:
Set the latency to the maximum setting of 4096 Samples.

3. Quality:
Drop the quality to around 30%.

4. Display Refresh Speed:
This can be turned to 0% once you've setup your processing.

A combination of the above settings will help spread the processing load on your computer.


Still need help? Contact Us Contact Us